HyperLite F4 OSD Flight Controller


$46.00

One of the most popular FC’s is back and better than ever, combining an industry favorite layout with new feature sets for freestyle, long range, and racers. Finally, a board for every pilot!

The new Hyperlite F4 OSD takes the same celebrated ‘flat-bottomed’ layout (crucial for clean and tight builds) and adds a much appreciated OSD and SIX UART ports (more than any other board on the market!) for GPS, RX, SmartAudio, and even Camera Control.

And with more features, comes improved ease of use with a built-in 4-in-1 ESC socket and included harnesses for HobbyWing, AiKON AK32, and Spedix GS35 4in1 ESCs. The built-in solder pads mirror the 4in1 pad layout, so you can easily connect ANY ESC to this board to get features like current sensing and ESC telemetry (for the BL32 guys).

PLEASE NOTE: The Hyperlite F4 OSD uses it’s own BF target .bin, “PYRODRONEF4”.

Specifications:

MPU6000 Gyro
STM32F405 CPUE @ 168mhz, can be overclocked
2-6S direct battery input
3.3V 100ma, 5V 1.2A BEC
5V Camera Power
Built in configurable Betaflight OSD
Flat bottom PCB for SUPER CLEAN builds
36x36 PCB with 30.5x30.5 mounting holes
6 UARTS. UART1 (INVERTER FOR SBUS),
UART2 (FREE),
UART3 (INVERTED TELEMETRY),
UART4 (Free),
UART5 (Smart Audio)
UART4 (Free)
Built in 4 IN 1 ESC socket(including ESC telemetry, External current sensor)
Plug and plug with the most popular 4-in-1 ESCs (HobbyWing, Airbot, Spedix, Aikon),with supplied cables
Built in solder pads mirror of the 4-in-1 ESC socket
Printed layout instructions ON the board - no need for instructions!

Please de-pin the esc side carefully using exacto knife or pair of fine tip tweezers. Please refer ESC connection photos.

Important Notes:

Before soldering or mounting any flight controller, connect it to your PC and verify operation Incorrect soldering techniques will damage this board and void warranty. Please use the correct sized tip, temperature and technique. Temp controlled soldering irons (such as the TS100) are available for under $100 and will make soldering much easier

Lifted pads are a result of incorrect soldering techniques or excess mechanical pressure and will not be covered under warranty.

USB ports must be handled with care, breakage of usb ports are not covered under warranty

Always use a smoke stopper before powering your build for the first time.

List Price: $46.00
Price: $46.00
SKU: HYPF4OSD


In Stock: Totally in stock right now